Accessories

Display:  List Grid

Showing 25–33 of 33 results

  • The metal worm clamps are designed for fixing ductwork to inline motors. Clamps are a good substitute for traditional duct tape that may loose it's hold over time. Packs of two.

    4.50 out of 5
    $8.00
  • Single roll of hanging tape. 30m (approx)

    5.00 out of 5
    $9.00
  • An access panel in plastic.
     
    Enable quick and easy access to concealed equipment and utility lines.
     
    Our panels can be wall or ceiling mounted.

    $41.00
  • This simple thermostat is used to control the fan found in Heat Transfer kits and systems. It can be used in heat and cool applications by wiring the thermostat as required – Electrician Required for installation.

    The thermostat does not use batteries. It has a on/off switch on the side of the unit, so the fan is either always off, or controlled by the thermostat setting.

    It is usually placed in the same room as the heater so it will turn on the fan once that room is warm and the extra heat can be taken to other rooms. Once the temperature drops, because to much heat has been taken or the heater has been turned off, the thermostat will turn off the fan.

    The thermostat can be wired one of two ways. To either operate until the room reaches the preset temperature or to operate starting from the preset temperature. We usually recommend the latter, this ensures your room with the heat source gets warm enough before you transfer the heat to other rooms.

    For installation instructions and wiring diagram click the PDF symbol to the right.

    $99.00 $59.00
  • Add this product to your shopping cart if you wish for us to install a flex and plug to your fan. The cord on this plug in 1m (3 pin) in length.

    Please Note: We are unable to accept returned fans that have a flex and plug installed.

     

    Note: This lead and plug option can only be used in conjunction with specific fans – Please refer to compatible accessories below product listings.

    $15.00
  • Add this product to your shopping cart if you wish for us to install a flex and plug to your fan. The cord on this plug in 1m in length.

    Please Note: We are unable to accept returned fans that have a flex and plug installed.

     

    Note: This lead and plug option can only be used in conjunction with specific fans – Please refer to compatible accessories below product listings.

    $15.00
  • A flush built in mounted uint box for use with the VKM variable speed controller.

    $10.00
  • A surface mounted junction box for use with the VKM variable speed controller.

    5.00 out of 5
    $10.00
  • The Speed controller is used for smooth speed control of domestic fans. Controller must be placed in the mounting box.

    Basic Technical Specification

    • Supply Voltage 230v, 50/60Hz
    • Output power, not more than 300w (load current not more than 1.8a)
    • Overall Dimensions, not more than 78x78x63mm
    • Weight, not more than 0.11kg
    • IP40 Rated

    The controller casing is made of plastic. The controller is featured with high efficiency and control accuracy. Switching to the maximum speed is effected by means of regulating the control knob. Regulating starts from the minimum to the maximum voltage value for the fan stable running. The minimum speed is set by means of the potentiometer at PCB. Controller must be installed onto vertical wall in hidden or external mounting box inside premises.

    4.00 out of 5
    $69.00