Note:
- a wall switch or thermostat (see accessories) can be used to turn the kit on
- the vent in the destination room should be placed as far away from the door as possible
If extra duct, vents or joiners are needed we have a range of heat transfer parts.
If you would like to view our general Heat Transfer Kit installation guide click here
About this kit
This is our basic offering for 1-2 rooms and the kit comes with the TT Mixflow 150 fan, which as the below table illustrates is more than capable of performing with this amount of ducting (12m).
| No Duct | 6m Duct | 12m Duct | 20m Duct | 30m Duct | 40m Duct | |
|---|---|---|---|---|---|---|
| TT Mixflow 150 | 520 m3/hr | 450 m3/hr | 400 m3/hr | 300 m3/hr | 250 m3/hr | 200 m3/hr |
*These figures are all based on duct-work of the same diameter as the fan and are approximate calculations. This kit is provided with 12m of ducting. Figures are based on the fan wired to the high speed.
Installation
The kits can be installed by the client as it is relatively easy to install. Some handyman skills are required to make holes in the plaster, etc. An electrician is needed to provide power to the fan (or a power point) and a switch, also to install a thermostat if required. The electrician can also install the system at the same time.
The fan is provided with a lead and plug, so it can be plugged in to an available power point which an electrician could install independent of the system installation.
An optional thermostat is available (see accessories below) BUT NOTE THAT AN ELECTRICIAN WILL THEN BE REQUIRED TO INSTALL IT.
Nick (verified owner) –
Review was left without specific comments
Jarrod (verified owner) –
It has been brilliant for our house, it is transferring heat to 5 rooms out of 1 vent
Matthew –
Lance –
quiet operation. easy to install. although i didnt like attaching pipe to motor in hot roof. sweat got all over tape etc. going to expand system works really well and interfgrated into google home for easy operation