- a wall switch or thermostat (see accessories) can be used to turn the kit on
- the vent in the destination room should be placed as far away from the door as possible
If extra duct, vents or joiners are needed we have a range of heat transfer parts.
If you would like to view our general Heat Transfer Kit installation guide click here
About this kit
This 1-3 room kit comes with a plastic centrifugal inline fan. A centrifugal fan is supplied with this kit because this stye of motor is best equipped to retain its capacity over not only long duct runs, but also duct setups that have more bends and Y junctions in place. This is our entry level 3 room kit.
The Centrifugal motors also have the added benefit that they can be speed controlled via a dimmer style switch. For this reason they are a popular choice for customers who would like to have more control of the speed.
The kits can be installed by the client as it is relatively easy to install. Some handyman skills are required to make holes in the plaster, etc. An electrician is needed to provide power to the fan (or a power point) and a switch, also to install a thermostat if required. The electrician can also install the system at the same time.
The fan is provided with a lead and plug, so it can be plugged in to an available power point which an electrician could install independent of the system installation.
An optional thermostat is available (see accessories below) BUT NOTE THAT AN ELECTRICIAN WILL THEN BE REQUIRED TO INSTALL IT.